Toyota 8FGCU30 User Manual

11. Low speed lever setting
Model
Except for
8FD20 to 30
for DPF
8FD20 to 30
for DPF
Lever angle
Pump speed
rPm
1 0.75 (0.046) or less I
-
390
490
390
1 Confirmation
In'ection rate
4
1500 St.1 CY~
(cu.in.1500 st. I cyl)
L
12. Idling speed, no-load maximum engine speed
2.5 to 5.5
(0.1 53 to 0.336)
0.75 (0.046) or less
2.5 to 5.5
(0.153 to 0.336)
Deviation
cm3 (cu.in.J
I All models
I
750 + 25
Remarks
1.5 (0.092)
or less
-
1.5 (0.092)
or less
Model
1
See the repair manual for each model
Low speed lever
setting
Confirmation
Low speed lever
setting
COOLING SYSTEM
THERMOSTAT
Idling speed
rpm
I Opening temperature "c (OF) I 80 to 84 (1 76 to 183) I
No-load maximum speed
rpm
Fully opened temperature "c (OF)
I 95 (203) I
I
Fully opened lift mm (in.) I 10 (0.39)
LUBRICATION SYSTEM
OIL PUMP
I Oil pump type
Trochoid pump
Body clearance
Tip clearance
mm (in.)
Standard
Limit
mm (in.)
0.10 to 0.17 (0.0039 to 0.0067)
0.2 (0.0079)
Rotor protrusion mm (in.)
Standard
Limit
0.05 to 0.1 5 (0.0020 to 0.0059)
0.2 (0.0079)
Standard
3.91 to 3.97 (0.1539 to 0.1
563)
(Reference)
1DZ-II Repair
Section 1.2.8

Toyota 8FGCU30 Specifications

General

Model	8FGCU30
Category	Forklifts
Engine Type	Internal Combustion
Load Capacity	6, 000 lbs
Maximum Lift Capacity	6, 000 lbs
Tire Type	Pneumatic
Fuel Type	Gasoline/LPG
Power Source	Internal Combustion
Engine Model	Toyota 4Y
Mast Type	3-stage