Toyota 8FGCU30 User Manual

2-35
DISASSEMBLY, INSPECTION AND REASSEMBLY
Disassembly and reassembly procedure
The reassembly procedure is the reverse of the disassembly procedure.
Procedure
I Item I Disassembly I Inspection / Reassembly
1 I Cylinder head assembly I see p.2-10 I t I t
2 1 Timing gear parts I see p.2-20 I t I t
3 1 Oil strainer I I I
4 1 Rear oil seal retainer with oil seal I I I
5 / Rear oil seal I I / [point 121
6 1 Measure the thrust clearance of the connecting rod. 1
7 1 Connecting rod cup with bearing I I [Point 21 1 [Point 111
10 1 Measure the thrust clearance of the crankshaft. / ( [point 51 1
8
9
13 1 oil regulator I I I
Piston with connecting rod
Piston disassembly
11
12
[Point 31
Crankshaft cap, bearing, thrust washer
Crankshaft
[Point 41
[Point 61
[Point 101
[Point 91
[Point 71
[Point 81
1DZ-II Repair
Section 1.2.2

Toyota 8FGCU30 Specifications

General

Model	8FGCU30
Category	Forklifts
Engine Type	Internal Combustion
Load Capacity	6, 000 lbs
Maximum Lift Capacity	6, 000 lbs
Tire Type	Pneumatic
Fuel Type	Gasoline/LPG
Power Source	Internal Combustion
Engine Model	Toyota 4Y
Mast Type	3-stage