ENGINE OILmOIL FILTER
REPLACEMENT
1. Drain the engine oil.
(1) Remove the oil filler cap.
(2) Remove the oil drain plug and drain the oil.
2.
Use the SST and remove the oil filter.
SST 09228-76001 -71
(09228-06501
)
3. Install the oil filter.
Hand tighten the oil filter with an O-ring fitted. Use the SST to
tighten an additional 314 turn from the hand-tight position.
SST 09228-76001 -71
(09228-06501
)
Caution:
Apply a small amount of engine oil to the O-ring.
Clean the surface to which the O-ring will be attached.
4. Pour in engine oil.
(1) Install the oil drain plug with a new gasket.
Caution:
Befolre attaching the plug, remove the old gasket stuck on the
oil pan and clean the surface to which the new gasket will be
attached.
(2) Pour in engine oil.
Oil pan capacity:
4.0
1
(1.1
US
gal)
(3) Attach the oil filler cap.
5.
lnspect the oil level.
Check using the oil level gauge.
6. lnspect for oil leaks.
Start the engine, and check that no oil is leaking.
7. Check the oil level.
After inspecting for oil leaks, check the oil level again.
Note:
Wait
3
minutes after stopping the engine before checking the
oil level.
To Next Page
Loading...
Need help?
General
