BAS-SVX50F-EN 17
Installing the Tracer TD7 Display
Setting Up and Using the TD7 Display Portable Carry Case
The TD7 Display Portable Carry Case (PN: X18210613010) is recommended when a TD7 display will
be used on more then one Tracer UC600. The case protects the TD7 display when not in use, stores
the power and Ethernet cables, and is equipped with a handle to carry the display.
Setting Up the TD7 Portable Carry Case
20. Connect the supplied Ethernet cable to the TD7 display.
21. Position the TD7 operator display inside the carry case, with the op
erator display facing
outward through the display opening (Figure 5). Route both the power cable and the Ethernet
cable through the small opening in the back of the case that leads to the pouch.
22. Securely close the portable carry ca
se using the attached
zipper.
23. Snip off the blue and gray wires from the unattached power cable so
only the red and black
wires remain.
24. Using a supplied terminal block, Insert the red wire through the 24
VAC connection, and the
black wire through the ground connection.
Note: Do not connect the wired terminal block to the UC600 at this stage in the pr
ocedure.
25. Connect the power cable (with the attached terminal block) to the TD7 display power cable.
Figure 5. TD7 Portable Carry Case
Front View
Back View
Display opening
Velcro closure
Attached pouch for
cables, ties, and
related tools
Supplied hook for
optional use
To Next Page
Loading...
Need help?
General
