TVS NTORQ 125 User Manual

65
Always make sure, whenever the wheel is removed, the
axle nuts are tightened properly to the specified torque.
Caution
FRONT WHEEL REMOVAL AND REASSEMBLY
Disc brake
1. Remove the axle nut (1) along with a washer.
2. Pull out the axle (2) along with a washer and take
out a spacer from the left side of the wheel.
3. Place a support below the foot board to prevent
vehicle from falling and lift the vehicle up.
4. Dislocate the wheel disc from caliper assembly
and take out the wheel along with hub drive.
5. Reverse the procedure for reassembling. Ensure
the proper seating of wheel disc in the caliper
assembly and lug on fork leg R to the slot in the
hub drive while reassembling.
1
2
REAR WHEEL REMOVAL AND REASSEMBLY
1. Place the vehicle on the centre stand.
2. Hold the rear brake firmly and remove the wheel
mounting nut (1) along with a washer.
3. Slightly tilt the vehicle and take out the wheel
from the rear axle.
4. Reassemble the wheel in the reverse order of
removal.
1

TVS NTORQ 125 Specifications

General

Displacement	124.8 cc
Max Torque	10.5 Nm @ 5, 500 rpm
Fuel System	Fuel Injection
Transmission	CVT
Front Brake	Disc
Rear Brake	Drum
Kerb Weight	118 kg
Front Tyre	100/80-12
Rear Tyre	110/80-12
Starting Method	Electric Start
Tyre Type	Tubeless
Seat Height	770 mm
Ground Clearance	155 mm
Engine Type	Single Cylinder, 4-Stroke, Air Cooled
Front Suspension	Telescopic
Fuel Tank Capacity	5.8 liters
Wheelbase	1285 mm
Rear Suspension	Coil Spring, Hydraulic Damped