Unify OpenStage 40 T User Manual

92 Making calls in the team/executive/secretary configuration
Trunk keys
The programmable sensor keys on multi-line phones function as trunk keys. Ev-
ery sensor key programmed as a "Trunk key" (key label: Transfer
Trk)
corresponds to a trunk with the result that you can configure up to six trunks
in OpenStage
40 T.
As a team member, you can independently program the following functions on
sensor keys
 Page 64:
• Direct station select
• Join/leave group
(not available on executive phone in an executive/secretary team)
• Ring Transfer: On/Off
(only in an executive/secretary team)
You can also program a sensor key with the function "Forward Line" (call for-
warding) for each line.
LED displays on trunk keys
Answering calls with the trunk keys
Prerequisite: Your telephone rings or the trunk key flashes quickly.
if nec. T Press the trunk key that is flashing quickly. 
(not necessary if "Prime Line" is active).
^ Lift the handset.
or On-hook dialing: Speakerphone mode.
Dialing with trunk keys
if nec. S Press the free trunk key you wish to use to establish the connection
(not necessary if "Prime Line" is active).
j Dial the phone number.
^ If the party does not answer: Lift the handset.
or On-hook dialing: Speakerphone mode.
LED Explanation
S Off – The line is in idle mode.
T Flashing
1
1 In this manual, flashing sensor keys are identified by this icon, regardless of the flashing interval.
The flashing interval represents different statuses, which are described in detail in the corre-
sponding sections of the manual.
– Incoming call on the line
– Hold reminder is activated
– The line is on "Hold".
R On – The line is busy.

Unify OpenStage 40 T Specifications

General

Speakerphone	Yes
Base station keys	12
Mac compatibility	No
Display diagonal	5.1 \
Display resolution	240 x 128 pixels
Display number of lines	6 lines
Display number of colors	Monochrome
Product color	Blue