110
I
PaX-i3D Smart
9. Troubleshooting
If a problem occurs while operating this equipment, perform the corresponding
troubleshooting measure outlined in the table below. If the problem persists, please
contact our customer support staffs.
If the device is not moving
Cause Solution
Power failure Check the equipment’s power supply.
Initialization status
Wait until the equipment has initialized and then try
again.
Control PC connection
failure
Check the connection status of Communication
Port(Optic) which connects the PC to the equipment.
If the exposure switch is not functioning
Cause Solution
Ready status
Check whether it is ready for capturing at the console
software.
If imaging cannot be performed
Cause Solution
Initialization status
Wait until the equipment has initialized and then try
again. If this problem persists, restart the equipment.
To Next Page
Loading...
Need help?
General
