VTech IS8128-5 User Manual

62
Device list and connection
Up to 2 devices can be paired to the
telephone base. All paired devices are
shown on the device list. To use a paired
device, it must be connected. Both
Bluetooth enabled devices can be used
on a cell call at a time.
Once you have paired a device with the
telephone base, you do not need to
repeat the pairing procedure again
unless you delete the device from the
device list.
NOTE
• When connecting a Bluetooth device
to the device list, all connected devices
will be temporarily disconnected until
the procedure is complete. It may take
up to two minutes to reconnect.
Review the device list
1. Press MENU/SELECT on the telephone
base in idle mode to enter the main
menu.
2. Press q CID or p to
highlight Bluetooth, then press
MENU/SELECT.
3. Press MENU/SELECT again to select
Device list.
Connect/disconnect an active device
While in the device list menu, you may
connect or disconnect your active device.
1. Press MENU/SELECT on the telephone
base in idle mode to enter the main
menu.
2. Press q CID or p to
highlight Bluetooth, then press
MENU/SELECT.
3. Press q CID or p to
highlight Device list, then press
MENU/SELECT.
4. Press q CID or p to highlight a
device, then press MENU/SELECT.
5. Press q CID or p to highlight
Connect/Disconnect (whichever
is applicable), then press
MENU/SELECT. The telephone base
displays Device connected/Device
disconnected. You hear a confirmation
tone.
NOTE
• When your active device is connected,
you are prompted to select
Disconnect. When your active device
is disconnected, you are prompted to
select Connect.

VTech IS8128-5 Specifications

General

Brand	VTech
Model	IS8128-5
Category	Cordless Telephone
Language	English