BA ET16 de* 1.0 * et16i400.fm 4-35
Putting into operation 4
Starts the engine
Control lever base
Raise the control lever base A after stopping the engine.
Control lever base raised:
• The engine will not start unless the control lever base is raised.
Control lever base lowered:
• The engine cannot be started.
All hydraulic functions are locked if the control lever is raised with a
running engine.
Functional check of control lever base
Before starting work, perform a functional check of the control lever base.
1. Start the machine.
2. Fold down the control lever base A.
3. Perform machine travel on open terrain.
4. Secure the danger zone.
5. Stop the machine.
6. Fold up the control lever base A.
7. Move all control levers and pedals in all directions.
➥ The selected elements do not move:
➥ Work may be performed with the machine.
8. The selected elements move:
➥ Stop operation immediately.
Contact a Wacker Neuson service center and have the malfunction
rectified.
Possible damage if the engine is started again immediately after stopping
it.
► Wait at least two minutes before starting the engine again.
Possible damage to preheater if the preheating system is operated too
long.
► Do not preheat the engine more than five seconds.
Fig. 98 (symbolic representation)
A
To Next Page
Loading...
Need help?
General
