Operation
Track offset
100
BA RD24_RD27 en 04
3.22 Track offset
Compacting work along kerbs or similar borders cannot be carried out, or
only in a limited way, without track movement of the drums.
A track adjustment especially developed for this problem enables the
machine to drive very precisely along such problem areas.
Adjust track movement
WARNING
Unintentional movement of the machine!
Severe injury or death by unexpected machine movements during
readjustment.
■
Do not perform any readjusting work unless the engine is stopped
and the ignition switched off.
■
Park the machine on safe ground, i.e., Flat and horizontal ground
with sufficient bearing capacity.
■
Secure machine against rolling away.
NOTICE
Wrong performance of track offset readjustment!
Damage to the steering system due to wrong track offset readjustment.
■
Do not use any lever tool (e.g., erection bar, other bars) for
readjusting the track offset.
■
Always perform track offset adjustment exclusively at the
console of the articulated pendulum joint and never on any other
component of the steering system.
NOTICE
Sharp-edged tools!
Damage to paint work when using unsuitable tools.
■
Do not apply any sharp-edged tool to a painted surface when
readjusting the track offset.
Remove any steering angle before parking the machine.
Switch off diesel engine and remove ignition key.
To Next Page
Loading...
Need help?
General
