Maintenance
Water sprinkling
160
BA RD24_RD27 en 04
Sprinkler nozzle check for additive sprinkling
Press and hold the switch [3] or foot switch [4].
a
The additive sprinkler will be active as long as one of the switches is
pressed and held.
Release switch [3] or [4].
a
Additive sprinkling turned off.
Latch driving lever in position 0.
Switch off the electrical system.
NOTE
If the sprinkler does not work or does not produce the desired
sprinkling pattern, the sprinkler nozzles need to be cleaned.
4.08.02 Cleaning sprinkler nozzles
Switch off diesel engine and remove ignition key.
Loosen the cap nut [7] and remove it together with sprinkler nozzle [6]
and filter [5].
Remove the filter and the sprinkler nozzle from the cap nut and clean
them.
Unscrew the cap nut [1].
Remove valve insert [2] and membrane [3].
Flush the housing [4] with the sprinkling system.
Insert the valve core [2] and diaphragm [3] into the union nut [1].
Screw the union nut [1] together with the valve core [2] and
diaphragm [3] onto the enclosure [4].
Insert the filter [5] and spray nozzle [6] into the union nut [7].
Screw the union nut [7] together with the spray nozzle [6] and filter [5]
onto the enclosure [4].
4.08.03 Cleaning filter for water sprinkling
A large, corrosion-free water filter is arranged upstream of the water
pump. It prevents premature contamination of pump, lines and spraying
nozzles, thus ensuring trouble-free operation. The maintenance of the
water filter depends on the purity of the water used. Only use clean
water!
To Next Page
Loading...
Need help?
General
