Auxiliary equipment
HAMM line spreader
218
BA RD24_RD27 en 04
At the end of the spreading work, with the machine at a standstill,
empty most of the remaining chips out of the storage container.
Switch off diesel engine and remove ignition key.
Loosen the fixing screws [1] (from the outside to the inside), and
swing down.
After loosening the last fixing screw [1], the spreader floor [2] can be
flapped down.
Remove the rest of the chips, and lean the spreader apertures [3].
Fold up the spreader bottom [2].
Fold up and tighten the retaining screws [1] (from the inside to the
outside).
Determine the quantity of chips
The exact setting for the quantity of chips is determined by tests
conducted according to the following procedure:
Open the shut-off slider: Set the lever to a scale value of 20.
Set the spreader shaft speed to maximum rotational speed.
Perform a sprinkle test by sprinkling a paper sheet 297 × 210 mm
(DIN A4) (11.69 × 8.27").
Weigh the chips from the paper sheet or fill it into a metering box
(size 100 ml (0.26 US gal.)).
Compare amount with tabular value.
If the correct rate of spread is not reached, readjust the shut-off slider
or the vehicle speed and repeat the test.
Rough estimate for the quantity of chips on a 297 × 210 mm sheet of
paper at a chip density of about 1.6 kg/dm³.
Quantity of
chips required
kg/m²
Weight of
chips on the
sheet of paper
g
Volume of
chips on the
sheet of paper
ml (US gal.)
Part of the
amount in the
metering box
0.5 31 20 1/5
1.0 62 40 2/5
1.5 94 60 3/5
2.0 125 80 4/5
2.5 156 100 5/5
6.06.04 Maintenance
For all maintenance work on the chip spreader, you must observe
the information listed in the chapter "Important information about
maintenance work", see page 123. Replace wear parts according to the
descriptions given in the manufacturer's operating manual.
Check operating and safety notes on the chip spreader.
Replace damaged and/or non-readable warning signs.
Ensure that hinges and links move easily and lubricate lightly.
Check that hydraulic and lighting connections are tight.
Check lighting.
Check screw connections which are heavily loaded and make sure
they have a tight seat.
To Next Page
Loading...
Need help?
General
