wsm L2800 Workshop Manual

9-S53
L3130 · L3430 · L3830 · L4630 · L5030, WSM
ELECTRICAL SYSTEM
Flasher Unit Actuation Test
1. Set the hazard switch to the ON position, and make sure the
hazard light gives 60 to 85 flashes for a minute.
2. Set the main switch to the ON position and move the turn signal
switch to the left. Make sure the left-hand light gives flashes.
Then move the turn signal switch to the right and make sure the
right-hand light gives flashes. Make sure the same actions as
above result.
3. If both the hazard switch and the turn signal switch function but
the above actions do not take place, replace the flasher unit with
new one.
W1048275
[6] WARNING LAMPS
(1) Checking
Engine Oil Pressure Switch Panel Board and Wiring Harness
1. Disconnect the lead (2) from the engine oil pressure switch after
turning the main switch OFF.
2. Turn the main switch ON and connect a jumper lead from the
lead to the chassis.
3. If the engine oil pressure indicator lamp does not light, the panel
circuit or the wiring harness is faulty.
W10259540
Engine Oil Pressure Switch Continuity
1. Measure the resistance across the switch terminal and the
chassis.
2. If 0 Ω is not indicated in the normal state, the switch is faulty.
3. If infinity is not indicated at pressure over 4.9 kPa (0.5 kgf/cm
2
, 7
psi), the switch is faulty.
W10260840
(1) Hazard Switch
(2) Turn Signal Switch
(3) Flasher Unit
(1) Engine Oil Pressure Switch
(2) Switch Lead
(a) From Oil Pressure Lamp
Resistance
(Switch terminal –
Chassis)
In normal state 0 Ω
At pressure over
approx. 4.9 kPa
(0.5 kgf/cm
2
, 7 psi)
Infinity
(1) Engine Oil Pressure Switch
KiSC issued 02, 2007 A

wsm L2800 Specifications

General

Brand	wsm
Model	L2800
Category	Tractor
Language	English