System Settings
101
Allocate Memory
This feature allows you to specify memory capacities required for printing and for the
receive buffer for each interface.
1.
Select [Allocate Memory] in the
[Features] menu.
2.
Change the required settings.
Use the scroll buttons to switch
between screens.
3.
Select [Close].
PostScript Memory
Specifies the PostScript memory capacity within the range of 16.00-96.00 MB in 0.25
MB increments using the scroll buttons or the numeric keypad. The currently available
memory will be displayed at the top of the screen with the following message: “Memory
Available: XXX MB.”
Receiving Buffer - USB
Specifies the input buffer memory capacity for the USB interface within the range of 64-
1024 KB in 32 KB increments using the scroll buttons or the numeric keypad. The
currently available memory will be displayed at the top of the screen with the following
message: “Memory Available: XXX MB.”
Receiving Buffer - LPD
Specifies the input buffer memory capacity for the LPD interface. The currently
available memory will be displayed at the top of the screen with the following message:
“Memory Available: XXX MB.”
NOTE: When printing with the receiving buffer spooling set to [Memory] or [Hard
Disk], each page within a job is printed in the sequence assigned by the operating
system. However, sometimes pages between different jobs may not be printed in the
intended sequence if, for example, printing multiple copies of a single 1-page job. In
this case, set spooling to [Off], the default, to maintain the intended printing sequence.
NOTE: If [Job Submission Order] is selected under [LPD Print Queue] in [Other
Settings], this setting is fixed to [Spool to Hard Disk].
• No Spooling
Specifies no spooling. Allows you to change the input buffer memory capacity within
the range of 1024-2048 KB in 32 KB increments using the scroll buttons or the
numeric keypad.
• Spool to Memory
Specifies spooling to memory. Allows you to change the input buffer memory
capacity within the range of 0.50-32.00 MB in 0.25 MB increments using the scroll
buttons or the numeric keypad.
• Spool to Hard Disk
Specifies spooling to the hard disk.
To Next Page
Loading...
Need help?
General
