These are important questions which can affect the output of your booklet jobs, especially
if you are using full-page images and trimming the booklet edges.
Follow these tips
Follow these tips to ensure you get your desired output:
• Always run one or more test prints of your job before running a larger output quantity.
• Review your test prints for truncated images/text.
• If any images or text need shifting, use the various selections from your application’s
print driver; refer to your print driver’s Help information.
• Remember: it may take one or more test prints before you achieve your desired
output.
Problem solving
Jam clearance
Note
The top covers cannot be opened during normal operation or when the machine is idle.
The covers can be opened only when an indicator is lit and a jam/fault occurs within the
SquareFold Trimmer Module. For indicator details, refer to the control panel information
earlier in this section.
The paper path is shown in the above illustration. Clear any paper jams that may occur
along the paper path. If a jam occurs, the machine stops printing, and a message may
be displayed on the User Interface (UI).
Note
To determine if the jam/fault is within the finisher or with the SquareFold Trimmer
Module, always begin your troubleshooting with the SquareFold Trimmer Module.
User Guide23-12
SquareFold Trimmer Module
To Next Page
Need help?
General
