Xerox VersaaLink B600 User Manual

Printer is Making Unusual Noises
SolutionsProbable Causes
Power off the printer, then remove the obstruction or
debris. If you cannot remove the obstruction, contact
your Xerox representative.
There is an obstruction or debris inside the printer.
Paper Tray Will Not Close
SolutionsProbable Causes
The paper tray does not fully close.
• If the tray is extended for legal-size paper, the tray
protrudes when it is inserted into the printer. For
more information, refer to Configuring Trays 1 or 2
for the Paper Length.
• Some debris or an object is blocking the tray.
• The tray is blocked by the table or shelf on which it
is located.
• If the paper lift plate at the back of the tray is not
locked down, replace the tray.
Condensation Has Formed Inside the Printer
Moisture can condense in the printer when room humidity exceeds 85% or when a cold printer is located
in a warm room. Condensation can form in a printer after it has been sitting in a cold room that is heated
quickly.
SolutionsProbable Causes
Allow the printer to operate for several hours at room
temperature.
The printer has been sitting in a cold room.
The relative humidity of the room is too high.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature
and relative humidity are within the operating spe-
cifications. For more information, refer to Environ-
mental Specifications.
8-5Xerox
®
VersaaLink
®
B600/B610 Printer
User Guide
Troubleshooting

Xerox VersaaLink B600 Specifications

General

Brand	Xerox
Model	VersaaLink B600
Category	Printer
Language	English