Powering On the Machine
Xerox® WorkCentre® 3025
User Guide
12
Powering On the Machine
The power button is located on the control panel. The power cable socket is located at the rear of the
printer.
1. Connect the AC Power Cord to the machine and a power outlet. The power cord must be plugged
into a grounded power socket.
2. The printer will connect to a wireless network, if available, when powered on. See the Installation
and Setup chapter of this guide for instructions on setting wireless settings.
3. Connect the network cable, if required.
Note: The 3025NI will not connect to the wireless network while the network cable is attached.
4. To allow faxing, connect the telephone line to the LINE Connector.
5. Press the Power button on the control panel.
Note: Some options may be unavailable depending on your machine configuration and whether
the machine is in the Ready state.
Power Save
This machine contains advanced energy conservation technology that reduces power consumption
when it is not in active use. When the printer does not receive data for an extended period of time, the
Power Save mode becomes active and power consumption is automatically lowered.
To enter Power Save mode:
1. Press the Power Save button.
2. Use the Up/Down arrow buttons to select Power Save and then OK.
To Next Page
Loading...
Need help?
General