| Call Features | 55
4. Confirm the action.
Rejecting Calls with Do Not Disturb (DND)
You can enable DND to reject all incoming calls automatically when you do not want to be interrupted.
Before you begin
Check with your system administrator to find out if the DND feature is available on your phone.
Procedure
1. Go to OK > Call Features > Do Not Disturb.
On the CP930W/DD phone, go to Menu > Features > DND.
On the CP935W, go to More > Features > DND.
2. Select the desired line, and then press OK.
3. Enable DND.
4. Confirm the action.
The status bar displays the DND icon.
Note: On the CP930W/DD phone, to activate or deactivate DND quickly, select DND when the
phone is idle.
Ending Calls
You can end the current call at any time.
Procedure
Press or End Call.
Muting/Unmuting Audio
You can mute the microphone during an active call so that the other party cannot hear your discussion with
your colleagues.
Procedure
1. Press the mute key during a call to mute the microphone.
The mute icon appears on the phone screen. On the CP930W/CP935W, the mute touch key LEDs
change from green to red. On the DDPhone, the mute key LED glows red.
2. Press the mute key again to unmute.
The mute icon disappears from the phone screen. On the CP930W/CP935W, the mute touch key LEDs
change from red to green. On the DDPhone, the mute key LED turns off.
Note: On the CP935W, to mute or unmute quickly, you can press the mute key directly.
Holding and Resuming Calls
You can place an active call on hold and resume the call when you are ready. When you place a call on
hold, the held party may hear the music played by its sever.
To Next Page
Loading...
Need help?
General
