User Manual
10
Chapter 3 DVR INSTALLATION
3.1 HDD Installation
Caution： Please do not Install or take out hard drive when DVR is running!
(1) The model has a HDD drawer. Please use provided key to take out the HDD drawer and put
HDD into the drawer correctly.
(2) Remove screws and open DVR upper cover carefully;
(3) Insert Power Cord and data cable into Pin of hard drive securely;
(4) Put the upper cover back carefully, re-attach screws.
3.2 Camera and Monitor Connection
Connect camera cable to video input of DVR, and from video output of DVR to Monitor via BNC
connector (Refer to section2.2-Rear Panel); or
If the camera is a PTZ speed dome, you could connect RS485 A & B to the according port of
DVR respectively (refer to system figuration on Chapter 8).
3.3 Power Supply connection
Please only use the power adapter supplied with the DVR.
After power on please make sure the video I/O connection well, audio device with RCA cable.
To Next Page
Loading...
Need help?
General
