they must be on the same network segment.
4. Set End IP address.
This IP address must be different from the IP address set on the LAN Host Settings area, but
they must be on the same network segment.
5. Set Lease time.
Lease time can be set to 2 to 1440 minutes. It is recommended to retain the default
value.
6. Click Submit. As shown in Figure 3-11.
Figure 3-11
3.5.3 Bundled Address List
You can bind an IP address to a device based on its MAC address. The device will receive the same IP
address each time it accesses the DHCP server. For example, you can bind an IP address to an FTP
server on the LAN.
To add an item to the setup list, perform the following steps:
1. Choose Network Setting > LAN Settings.
2. Click Add list.
3. Set the MAC address and IP Address.
4. Click Submit. As shown in Figure 3-12.
Figure 3-12
To modify an item in the setup list, perform the following steps:
1. Choose Network Setting > LAN Settings.
2. Choose the item to be modified, and click Edit.
3. Set the MAC address and IP Address.
4. Click Submit. As shown in Figure 3-13.
To Next Page
Loading...
Need help?
General
