9.7 Date & Time
You can set the system time manually or synchronize it with the network. If you select Sync from
network, the CPE regularly synchronizes the time with the specified Network Time Protocol (NTP)
server. If you enable daylight saving time (DST), the CPE also adjusts the system time for DST.
To set the date and time, perform the following steps:
1. Choose System > Date & Time.
2. Select Set manually.
3. Set Local time or click Sync to automatically fill in the current local system time.
4. Click Submit. As shown in Figure 9-13.
Figure 9-13
To synchronize the time with the network, perform the following steps:
1. Choose System > Date & Time.
2. Select Sync from network.
3. From the Primary NTP server drop-down list, select a server as the primary server for time
synchronization.
4. From the Secondary NTP server drop-down list, select a server as the IP address of the secondary
server for time synchronization.
5. If you don’t want to use other NTP server, you need to enable Optional ntp server, and set a server
IP address.
6. Set Time zone.
7. Click Submit. As shown in Figure 9-14.
To Next Page
Loading...
Need help?
General
