ACS550 User’s Manual 241
Technical Data
Materials
Applicable Standards
Drive compliance with the following standards is identified by the standards “marks”
on the type code label.
Compliance is valid with the following provisions:
• The motor and control cables are chosen as specified in this manual.
• The installation rules of this manual are followed.
Material Specifications
Drive enclosure
• PC/ABS 2.5 mm, color NCS 1502-Y (RAL 90021 / PMS 420 C and 425 C)
• Hot-dip zinc coated steel sheet 1.5…2 mm, thickness of coating 20
micrometers
• Cast aluminium AlSi
• Extruded aluminium AlSi
Package
Corrugated board, expanded polystyrene, plywood, raw wood (heat dried).
Package wrap consists of one or more of the following: PE-LD plastic wrap, PP
or steel bands.
Disposal
The drive contains raw materials that should be recycled to preserve energy
and natural resources. The package materials are environmentally compatible
and recyclable. All metal parts can be recycled. The plastic parts can either be
recycled or burned under controlled circumstances, according to local
regulations. Most recyclable parts are marked with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed
circuit boards can be landfilled. The DC capacitors contain electrolyte and the
printed circuit boards contain lead, both of which will be classified as hazardous
waste within the EU. They must be removed and handled according to local
regulations.
For further information on environmental aspects and more detailed recycling
instructions, please contact your local ABB distributor.
Mark Applicable Standards
EN 50178 (1997) Electronic equipment for use in power installations
EN 60204-1 (1997 +
corrigendum Sep. 1998)
Safety of machinery. Electrical equipment of machines. Part 1:
General requirements. Provisions for compliance: The final
assembler of the machine is responsible for installing:
• An emergency-stop device
• A supply disconnecting device
EN 60529 (1991 +
corrigendum May 1993 +
amendment A1:2000)
Degrees of protection provided by enclosures (IP code)
EN 61800-3 (1996) +
Amendment A11 (2000)
EMC product standard including specific test methods
EN 61800-3 (1996) +
Amendment A11 (2000)
EMC product standard including specific test methods
UL 508C UL Standard for Safety, Power Conversion Equipment, second
edition
To Next Page
Loading...
Need help?
General
