ABB ACS550-01 User Manual

ACS550 User’s Manual 29
Start-Up
Status Information
Top. The top line of the LCD display shows the basic status information of the drive.
• LOC – indicates that the drive control is local, that is, from the control panel.
• REM – indicates that the drive control is remote, such as the basic I/O (X1) or
fieldbus.
• – indicates the drive and motor rotation status as follows:
• Upper right – shows the active reference.
Middle. Using parameter Group 34, the middle of the LCD display can be configured
to display:
• Up to three parameter values.
– By default, the display shows three parameters.
The particular parameters depend on the value of
parameter 9904
MOTOR CTRL MODE. For example,
if 9904 = 1, the display shows parameters 0102
(
SPEED), 0104 (CURRENT), 0105 (TORQUE).
– Use parameters 3401, 3408, and 3415 to select the parameters (from Group
01) to display. Entering “parameter” 0100 results in no parameter displayed.
For example, if 3401 = 0100 and 3415 = 0100, then only the parameter
specified by 3408 appears in the Control Panel display.
– You can also scale each parameter in the display, for example, to convert the
motor speed to a display of conveyor speed. Parameters 3402…3405 scale
the parameter specified by 3401, parameters 3409…3412 scale the parameter
specified by 3408, etc.
• A bar graph rather than any of the parameter values.
– Enable bar graph displays using parameters
3404, 3411 and 3418.
Bottom. The bottom of the LCD display shows:
• Lower corners – show the functions currently
assigned to the two soft keys.
• Lower middle – displays the current time (if configured to show the time).
Operating the Drive
LOC/REM – The very first time the drive is powered up, it is in the remote control
(REM) mode, and is controlled from the Control Terminal Block X1.
Control Panel Display Significance
Rotating arrow (clockwise or counter
clockwise)
• Drive is running and at setpoint
• Shaft direction is forward or reverse
Rotating dotted blinking arrow Drive is running but not at setpoint.
Stationary dotted arrow Start command is present, but motor is not
running. E.g. start enable is missing.

ABB ACS550-01 Specifications

General

Brand	ABB
Model	ACS550-01
Category	Controller
Language	English