62 Modbus/TCP – Start-up
Control locations
ABB drives can receive control information from multiple sources
including digital inputs, analog inputs, the drive control panel and a
fieldbus adapter module. ABB drives allow the user to separately
determine the source for each type of control information (Start,
Stop, Direction, Reference, Fault reset, etc.).
To give the fieldbus client the most complete control over the drive,
you must select the adapter module as the source of this
information. The drive-specific parameter setting examples below
contain the drive control parameters relevant in the examples. For
a complete parameter list, see the drive documentation.
To Next Page
Loading...
Need help?
General
