96 Devices
On selection of a drive from the list, the Device Parameters section displays settings of
the selected drive as follows:
• Modbus node id field represents the connection specific node ID of the drive, see
chapter Modbus/TCP gateway on page 45.
• Device Name field shows the name of the drive.
• Device Node field shows the node id of the drive.
Read-write flag is a drop-down list to select the access mode, specific to the
particular drive through the gateway. There are 2 options:
- Read-only
- Read-write.
• Read-write access IP address is an edit box, where the user can specify the IP
address from where the gateway accepts connections to this particular drive.
• Read-write access netmask is an edit box, where the user can specify the
netmask of the IP address from where the gateway accepts connections to this
particular drive.
• Timeout in milliseconds is an edit box, where the user can specify the maximum
waiting time for a response after each individual request, for this specific drive.
Panel bus tab
The Panel bus tab contains all the devices connected to the PNL connectors.
Interface settings
To open the Interface settings dialog box, click the Settings button on the toolbar. Every
connection type has its own Interface settings dialog box. The following two buttons are
common to each connection type:
• Save button saves the modified settings.
• Close button closes the dialog box without saving the settings.
To Next Page
Loading...
Need help?
General
