Altos R520 Installation Configuration Guide 86
from the driver diskette.
5. At the package selection step, select Software Development for the
installation package.
6. Please follow the normal procedure to finish the installation.
Gigabit Ethernet Driver Installation
NOTE. Please install the kernel-devel-<version> package with the CD #1 of
Red Hat Enterprise Linux 5 prior to install the Gigabit Ethernet driver.
1. You can find the Gigabit Ethernet driver in EasyBUILD. Please copy the
driver from the EasyBUILD to HDD first.
# mount /dev/dvd /mnt
# cp –R /mnt/Disk/R520/NIC/Intel/pro1000.lx/. /tmp
2. Remove the OS built-in NIC driver
# rmmod e1000.ko
3. Change the directory to the driver source and install the driver
# cd /tmp/src/
# make install
# insmod e1000.ko
4. Run the kudzu utility, it will auto detect the Gigabit Ethernet controller
and help you to configure it.
# kudzu
5. Restart the network service to bring up both of the network interfaces.
# service network restart
IOAT driver installation
1. Please remove the old version of IOAT driver from the system manually.
# cd /lib/modules/$(uname -r)/kernel/drivers/dma
# mv ioatdma.ko ioatdma.ko.bak
2. You can find the IOAT driver in EasyBUILD. Please copy the driver from the
EasyBUILD to HDD first.
Copy the IOAT driver to /tmp
# cd /tmp
# tar zxf ioatdma-<ioat version>.tar.gz
3. Install the IOAT driver
# cd ioatdma-<ioat version>
To Next Page
Loading...
Need help?
General
