Altos R520 Installation Configuration Guide 104
4. To start RAID Web Console 2 on, select applications -> System Tools ->
RAID Web Console 2 Startup UI
Red Hat Enterprise Linux 4.0 Update 3 Installation (with
integrated SAS hardware RAID)
Below information describes how to manually install Red Hat Enterprise Linux
4.0 Update 3 on Altos R520 with integrated SAS hardware RAID.
Drivers Required
For Red Hat Enterprise Linux 4.0 Update 3 Installation, the following device
drivers are required.
Device Version EasyBUILD Version
Integrated SAS
hardware RAID
00.00.03.03 EasyBUILD 7.1 build 400 (or later)
Onboard Chipset N/A OS built-in
Onboard Gigabit
Ethernet
7.0.38-NAPI EasyBUILD 7.1 build 400 (or later)
Onboard VGA N/A OS built-in
Onboard USB 2.0 N/A OS built-in
Software Required
The management utility of integrated SAS hardware RAID can be found in the
EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
1.13-07 EasyBUILD 7.1 build 400 (or later)
Configuring integrated SAS hardware RAID
Please refer to the Appendix A. for the integrated SAS hardware RAID
configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS hardware RAID in the Red Hat
Enterprise Linux 4.0 Update2. You need an external USB floppy drive to load
driver during the OS installation.
1. Since Red Hat Enterprise Linux 4.0 Update2 cannot recognize the
integrated SAS hardware RAID, you need to make a driver diskette from
the EasyBUILD first before the installation.
2. Type linux dd when the prompt boot: appears at the start.
3. Please select the sda as the Driver Disk Source.
4. Follow the instruction to load the integrated SAS hardware RAID driver
from the driver diskette.
To Next Page
Loading...
Need help?
General
