Altos R520 Installation Configuration Guide 154
# chmod 755 RunRPM.sh
# ./install.sh
3. Type y to accept the license agreen and select 1 for full installation.
4. To start RAID Web Console 2, click on start button, select System -> More
Programs -> RAID Web Console 2 Startup UI
SUSE Linux Enterprise Server 9 Service Pack 3 Installation (with
onboard SATA RAID)
Below information describes how to manually install SUSE Linux Enterprise
Server 9 Service Pack 3 on Altos R520 with onboard SATA RAID.
Drivers Required
For SUSE Linux Enterprise Server 9 Service Pack 3 Installation, the following
device drivers are required.
Device Version EasyBUILD Version
Onboard SATA
RAID
06.06.0728.20
06
EasyBUILD 7.1 build 400 (or later)
Onboard Chipset N/A OS built-in
Onboard Gigabit
Ethernet
7.0.38-NAPI EasyBUILD 7.1 build 400 (or later)
Onboard VGA N/A OS built-in
Onboard USB 2.0 N/A OS built-in
Software Required
The management utility of onboard SATA RAID can be found in the EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
1.13-07 EasyBUILD 7.1 build 400 (or later)
Configuring onboard SATA RAID
Please refer to the Appendix C. for the onboard SATA RAID configuration.
Installation Tips
NOTE. There is no built-in driver Onboard SATA RAID in the SUSE Linux
Enterprise Server 9 Service Pack 3. You need an external USB floppy drive to
load driver during the OS installation.
1. Since SUSE Linux Enterprise Server 9 Service Pack 3 cannot recognize the
onboard SATA RAID, you need to make a driver diskette from the
EasyBUILD first before the installation.
2. Boot the system form SUSE Linux Enterprise Server 9 Service Pack3
bootable CD.
To Next Page
Loading...
Need help?
General
