Altos R520 Installation Configuration Guide 82
# chmod 755 install.sh
# chmod 755 RunRPM.sh
# ./install.sh
3. Type y to accept the license agreen and select 1 for full installation.
4. To start RAID Web Console 2 on, select applications -> System Tools ->
RAID Web Console 2 Startup UI
Red Hat Enterprise Linux 5.0 EM64T Installation (with Onboard
SATA RAID)
Below information describes how to manually install Red Hat Enterprise Linux
5.0 EM64T on Altos R520 with onboard SATA RAID.
Drivers Required
For Red Hat Enterprise Linux 5.0 EM64T Installation, the following device
drivers are required.
Device Version EasyBUILD Version
Integrated SAS
hardware RAID
09.32.0207.20
08
EasyBUILD 8.0 build 100 (or later)
Onboard Chipset N/A OS built-in
Onboard Gigabit
Ethernet
7.6.5 EasyBUILD 8.0 build 100 (or later)
Onboard VGA N/A OS built-in
Onboard USB 2.0 N/A OS built-in
IOAT 2.15 EasyBUILD 8.0 build 200 (or later)
Software Required
The management utility of onboard SATA RAID can be found in the EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
2.19-01 EasyBUILD 8.0 build 100 (or later)
Configuring integrated SAS hardware RAID
Please refer to the Appendix C. for the onboard SATA RAID configuration.
Installation Tips
NOTE. There is no built-in driver for onboard SATA RAID in the Red Hat
Enterprise Linux 5.0 EM64T. You need an external USB floppy drive for
applying driver during the OS installation.
1. Since Red Hat Enterprise Linux 5.0 EM64T cannot recognize the
integrated SAS hardware RAID, you need to make a driver diskette from
the EasyBUILD first before the installation.
To Next Page
Loading...
Need help?
General
