Altos R520 Installation Configuration Guide 54
Onboard VGA 8.24.3.0 EasyBUILD 7.1 build 400 (or later)
Onboard USB 2.0 N/A OS built-in
IOAT 1.2.52.0 EasyBUILD 7.1 build 400 (or later)
Software Required
The management utility of integrated SAS SW RAID can be found in the
EasyBUILD.
Software Version EasyBUILD Version
Microsoft Scalable
Networking Pack
N/A
http://www.microsoft.com/downloads/
details.aspx?FamilyID=c65f4a89-f4da-
463e-a496-
4b5abd660bf9&DisplayLang=en
RAID Web Console
2
1.13-07 EasyBUILD 7.1 build 400 (or later)
Intel PROSet Utility 10.4.4.2 EasyBUILD 7.1 build 400 (or later)
Configuring integrated SAS SW RAID
Please refer to the Appendix B. for the integrated SAS SW RAID configuration.
Installation Tips
NOTE. There is no built-in driver of Integrated SAS SW RAID in the Windows
Server 2003. You need an external USB floppy drive for applying driver during
the OS installation.
1. As Windows Server 2003 can’t recognize the integrated SAS SW RAID, you
need to make a driver diskette from the EasyBUILD first before the
installation.
2. Press F6 at the start of installation to provide the driver disk for the
integrated SAS SW RAID.
3. Select “Intel Embedded Server RAID Technology II (Windows XP/2003)” as
target driver
4. After loading the RAID driver from diskette, follow the normal procedure
to finish the installation.
Chipset Driver Installation
1. After the installation completes, you would see the following devices
with yellow mark in Device Manager.
To Next Page
Loading...
Need help?
General
