Altos R520 Installation Configuration Guide 168
15. Press Enter again to select array to configure.
16. Press spacebar to select the array and press <F10> to configure the logical
drive
17.
The default RAID level for 2 disk drives is RAID1. Just select Accept to use
the default setting and press <Enter> to return to the
ARRAY SELECTION
MENU.
18. Press <Enter> to end the array configuration.
19. Select YES to Save Configuration and press any key to return to the
Configure menu.
Initial RAID Volume
20. Press <Esc> to return to the Management Menu.
21. Select Initialize from Management menu. All logical drives should be
listed under Logical Drives.
22. Press <Spacebar> to select drives for initialization. The selected drive will
be shown in yellow.
23. After selecting the drives, press <F10> and select YES to start the
initialization process.
24. When initialization is complete, press any key to continue.
25. Press <Esc> to return to the Management Menu.
Save and Exit Embedded RAID II Configuration Utility
26. When RAID configuration and initialization is complete, press <Esc> in the
Management Menu and select YES to exit the Embedded RAID
Configuration Utility.
27. Press <Ctrl> + <Alt> + <Del> to reboot the server.
To Next Page
Loading...
Need help?
General
