Altos R520 Installation Configuration Guide 8
2. Click on “Load Driver” when “Where do you want to install Windows”
message displayed.
3. Select “Intel(R) RAID Controller SROMBSAS18E (A:\oemsetup.inf)” as
target driver
4. After loading the RAID driver from diskette, you could click “Drive
options” to partition the drive.
5. Follow the normal procedure to finish the installation.
6. After the installation completes, you would see the following devices
with yellow mark in Device Manager.
Chipset Driver Installation
1. Please insert the EasyBUILD into the optical drive
2. Expand Drivers -> Altos R520 -> Chipset, select Windows Server 2008 x64
and click on Setup.
3. Follow the instruction to install the driver and reboot the server after the
chipset driver is installed.
Gigabit Ethernet Driver Installation
1. There is built-in Ethernet controller driver with Widows Server 2008 x64.
Please update the driver with EasyBUILD. Please do the same on both of
the devices.
2. Please insert the EasyBUILD into the optical drive
To Next Page
Loading...
Need help?
General
