Altos R520 Installation Configuration Guide 100
# chmod 755 install.sh
# chmod 755 RunRPM.sh
# ./install.sh
3. Type y to accept the license agreement and select 1 for full installation.
4. To start RAID Web Console 2 on, select applications -> System Tools ->
RAID Web Console 2 Startup UI
Red Hat Enterprise Linux 4.0 EM64T Update 3 Installation (with
integrated SAS SW RAID)
Below information describes how to manually install Red Hat Enterprise Linux
4.0 EM64T Update 3 on Altos R520 with integrated SAS SW RAID.
Drivers Required
For Red Hat Enterprise Linux 4.0 Update 3 Installation, the following device
drivers are required.
Device Version EasyBUILD Version
Integrated SAS SW
RAID
06.06.0728.20
06
EasyBUILD 7.1 build 400 (or later)
Onboard Chipset N/A OS built-in
Onboard Gigabit
Ethernet
7.0.38-NAPI EasyBUILD 7.1 build 400 (or later)
Onboard VGA N/A OS built-in
Onboard USB 2.0 N/A OS built-in
Software Required
The management utility of integrated SAS SW RAID can be found in the
EasyBUILD.
Software Version EasyBUILD Version
RAID Web Console
2
1.13-07 EasyBUILD 7.1 build 400 (or later)
Configuring integrated SAS SW RAID
Please refer to the Appendix B. for the integrated SAS SW RAID configuration.
Installation Tips
NOTE. There is no built-in driver Integrated SAS SW RAID in the Red Hat
Enterprise Linux 4.0 EM64T Update2. You need an external USB floppy drive to
load driver during the OS installation.
1. Since Red Hat Enterprise Linux 4.0 EM64T Update2 cannot recognize the
integrated SAS SW RAID, you need to make a driver diskette from the
EasyBUILD first before the installation.
To Next Page
Loading...
Need help?
General
