Altos R520 Installation Configuration Guide 66
2. Please insert the EasyBUILD into the optical drive
3. Expand Drivers -> Altos R520 -> Chipset and double-click on Windows
2000.
4. Follow the instruction to install the driver and reboot the server after the
chipset driver is installed.
Gigabit Ethernet Driver Installation
1. There are two Ethernet Controller listed under Other device in Windows
Device Manager. It should be the onboard Intel 82563EB Gigabit Ethernet
controller. You could find the driver in EasyBUILD. Please do the same on
the both of the devices.
2. Right-click on the Ethernet Controller and select Properties.
3. Select Driver tab and click on Update Driver.
4. Follow the instructions. Select Search for a suitable driver for my device
(Recommended) and click on Next.
5. Check on the Specify a location and click on Next to specify the path for
the driver.
6. Follow the instructions to finish the installation.
7. After installing the driver, you would see Intel(R) PRO/1000 EB Network
Connection with I/O Acceleration listed in Network adapters.
IOAT Driver Installation
1. For Base System Device, it should be the onboard IOAT device. You could
find the driver in Resource CD.
2. Right-click on the Base System Device and select Properties.
3. Select Driver tab and click on Update Driver.
4. Follow the instructions. Select Search for a suitable driver for my device
(Recommended) and click on Next.
5. Check on the Specify a location and click on Next to specify the path for
the driver.
6. Follow the instruction to finish the driver update.
7. After installing the driver, you would see Intel(R) 5000 Series Chipsets
Integrated Device – 1A38 listed in System devices.
Hot-swap Backplane Driver Installation
1. There is a ESG-SHV SCA HSBP M11.... SCSI Enclosure Device listed under
Other device in Windows Device Manager. It is the hot-swap SAS
backplane for R520.
2. Right-click on the ESG-SHV SCA HSBP M11.... SCSI Enclosure Device and
To Next Page
Loading...
Need help?
General
