Agilent Technologies 34970A Service Guide

To Prepare the Instrument for Use
1 Check the list of supplied items.
Verify that you have received the following items with your instrument.
If anything is missing, contact your nearest Agilent Technologies Sales Office.
One power cord.
One User’s Guide.
This Service Guide.
One Quick Reference Guide.
Certificate of Calibration (if you ordered the internal DMM).
Quick Start Kit (if you ordered the internal DMM):
• One RS-232 cable.
• BenchLink Data Logger Software CD-ROM.
• One J-type thermocouple and a flatblade screwdriver.
Any plug-in modules that you ordered are delivered in a separate
shipping container.
2 Connect the power cord and turn on the instrument.
The front-panel display will light up briefly while the instrument
performs its power-on self-test. The
GPIB address is displayed.
The instrument initially powers up with all measurement channels
turned off. To review the power-on display with all annunciators
turned on, hold down as you turn on the instrument. If the
instrument does not turn on properly, see page 42.
3Perform a complete self-test.
The complete self-test performs a more extensive set of tests than those
performed at power-on. Hold down as you turn on the instrument
and hold down the key until you hear a long beep. The self-test will begin
when you release the key following the beep.
On/Standby
Switch
WARNING
Note that this switch
is
Standby only.
To disconnect the
mains from the
instrument, remove
the power cord.
2
Chapter 2 Quick Start
To Prepare the Instrument for Use
35

Agilent Technologies 34970A Specifications

General

Brand	Agilent Technologies
Model	34970A
Category	Switch
Language	English