406 Chapter 14
Real Time TDMA Formats
PDC Framed Modulation
Configuring the RF Output
1. Set the RF output frequency to 832 MHz.
2. Set the output amplitude to 0 dBm.
3. Press
RF On/Off to On.
The user-defined PDC signal is now available at the signal generator’s RF OUTPUT connector.
To store this real-time I/Q baseband digital modulation state to the instrument state register, see “Saving an
Instrument State” on page 71.
To recall a real-time I/Q baseband digital modulation state, see “Recalling an Instrument State” on page 72.
To Next Page
Loading...
Need help?
General
