316 Chapter 10
CDMA Digital Modulation
Storing a Component Test Waveform to Memory
Storing a Component Test Waveform to Memory
In this section, you will learn how to store the component test waveform.
1. Press
Mode Setup hardkey to return to the top-level menu.
2. Perform the following keypress sequence required for your format type.
For CDMA2000 Waveform Format
a. Press
More (1 of 2) > CDMA2000 Define (Multicarrier Define when Multicarrier Off On is On) > Store Custom
CDMA State
(Store Custom Multicarrier when Multicarrier Off On is On) > Store To File.
If there is already a file name occupying the active entry area, press the following keys:
Edit Keys > Clear Text
b. Using the alphabetic menu and the numeric keypad, enter the file name using a maximum length of
23 characters.
c. Press
Enter.
For CDMA Waveform Format
a. Press
CDMA Define (Multicarrier Define when Multicarrier Off On is On) > Store Custom State (Store Custom
Multicarrier
when Multicarrier Off On is On > Store To File.
If there is already a file name occupying the active entry area, press the following keys:
Edit Keys > Clear Text
b. Using the alphabetic menu and the numeric keypad, enter the file name.
c. Press
Enter.
Your user-defined CDMA state file is now saved to the signal generator memory.
NOTE The RF output amplitude, frequency, and operating state settings are not stored as part of a
user-defined CDMA state file.
To Next Page
Loading...
Need help?
General
