Chapter 17 579
W-CDMA Downlink Digital Modulation for Receiver Test
Using W-CDMA Downlink
Configuring the Physical Layer
The steps in this procedure build upon the previous procedure.
1. Press
Return > Link Control > 5 > Enter.
2. Press
PhyCH Setup.
3. Move the cursor to highlight the Off value for DPCH data channel 2.
4. Press
Edit Item to toggle the channel on.
The data channel state changes each time you press
Edit Item. You can now move the cursor to edit other
data channel fields as well.
5. Press
Return.
6. Press
Channel State Off On to Off.
Notice that toggling the channel state not only turns off or on the selected physical channel (in this case
DPCH), but also turns off or on all of its data channels, which are shown in the table editor. To turn
individual data channels off or on, repeat steps 2 through 4.
7. Press
Channel State Off On to On.
8. Press
6 > Enter. (Or, press the right arrow key.)
9. Press
Channel State On Off to On > PhyCH Setup.
This activates the OCNS physical channel, turning on all 16 of its data channels, and accesses the table
editor. Refer to Figure 17-2.
To Next Page
Loading...
Need help?
General
