46 Rockwell Automation Publication 1756-UM001M-EN-P - February 2012
Chapter 3 Start Using the Controller
Set Up the USB Driver
To configure RSLinx software to use a USB port, you need to first set up a USB
driver. To set up a USB driver, perform this procedure.
1. Connect your controller and workstation by using a USB cable.
The Found New Hardware Wizard dialog box appears.
2. Click any of the Windows Update connection options and click Next.
3. Click Install the software automatically (Recommended) and click Next.
If the software for the USB driver is not found and the installation is canceled,
verify that you have installed RSLinx
®
Classic software, version 2.56 or later.
To Next Page
Loading...
Need help?
General
