ACTIVATION screen page
This screen page is used to delete errors in the
control unit memory and to activate some systems
controlled by the control unit.
ACTIVATION
Characteristic Value/example Unit of
measure
ment
Notes
Front brake bleeding procedure Useful in case of lever sponginess although the
bleeding has been done as in a regular braking
system
Rear brake bleeding procedure Useful in case of lever sponginess although the
bleeding has been done as in a regular braking
system
ABS warning light For Shiver, Shiver GT and Dorsoduro models, the
ABS warning light is caused to flash. For the Mana
model, both the EFI warning light and the ABS
word flash on the display.
Ambient parameter error reading (1) The ambient parameters are 4: Number of error
detections, Operation cycles from the last detec-
tion, Battery voltage, Speed.
Ambient parameter error reading (2) Number of error detections: number of times the
error has been detected by the control unit;
Ambient parameter error reading (3) for example, if it indicates 2, it means that the error
has been detected (ATT), then it has not been de-
tected for a while (sent to the MEM) and then it
has been detected again.
Ambient parameter error reading (4) Operation cycles from the last reading: a cycle is
counted if the following occurs: key ON and speed
over 20 km/h.
Ambient parameter error reading (5) If for example 5 is shown, it means that the last
time the error has been measured was 5 cycles
ago.
Error clearing (1) Press "enter" to transfer errors from the memory
(MEM) to the historical record (STO).
Error clearing (2) In the next connection between Navigator and the
control unit, the historical errors (STO) are no lon-
ger shown.
Braking system DORSODURO 1200 ABS - ATC
BRAK SYS - 354
To Next Page
Loading...
Need help?
General
