AFTER REMOVING THE PADS, DO NOT OPERATE THE BRAKE LEVER OR THE CALLIPER
PLUNGERS COULD GO OUT OF THEIR SEATS RESULTING IN BRAKE FLUID LEAKS.
Rear brake pads
Removal
•
Remove the cotter pin.
•
Remove the pin by sliding it back-
wards.
•
Extract one pad at a time.
CAUTION
AFTER REMOVING THE PADS, DO NOT OPERATE THE
BRAKE LEVER OR THE CALLIPER PLUNGERS COULD
GO OUT OF THEIR SEATS RESULTING IN BRAKE FLUID
LEAKS.
Bleeding the braking system
VEHICLE PREPARATION
•
It is important to check that there is always enough brake fluid in the reservoir.
•
Using a bleed device facilitates these operations while, in the meantime, the "Brake fluid
replacement" operations are performed.
Braking system DORSODURO 1200 ABS - ATC
BRAK SYS - 360