•
Location on the vehicle: under the fuel tank, left side, front relay box, second relay starting
from the front.
FAN CONTROL RELAY
•
Location on the wiring diagram: 38
•
Location on the vehicle: under the fuel tank, left side, rear relay box, third relay starting from
the front.
HIGH BEAM LIGHTS RELAY
•
Location on the wiring diagram: 7
•
Location on the vehicle: under the fuel tank, left side, rear relay box, first relay starting from
the front.
RECOVERY LOGIC RELAY (URGENT SERVICE)
•
Location on the wiring diagram: 23
•
Location on the vehicle: under the fuel tank, left side, front relay box, third relay starting from
the front.
Electrical system installation
INTRODUCTION
Scope and applicability
The position of the cable harnesses, how they are fixed to the motorcycle and potential problems are
defined on the following sections in order to reach the objectives of vehicle reliability.
Materials used and corresponding quantities
The electrical system consists of the following cable harnesses and parts:
•
1 Main Cable Harness
•
1 Taillight Cable harness
•
1 License Plate Light Cable Harness
•
1 Injection Main Relay
•
1 Relay Mounting Rubber Block
•
1 Start-up Relay
•
2 Small black clamps 2.5x98 mm (0.01x3.86 in)
•
13 Small black clamps 2.5x160 mm (0.01x6.30 in)
•
3 Medium black clamps 4.5x180 mm (0.18x7.08 in)
•
13 Medium black clamps 4.5x290 mm (0.18x11.42 in)
•
2 Mountings for the AMP Connector
•
1 Mounting for the Bosch Connector
•
1 Cable Harness Protection
•
2 Cable Harness Supports
Electrical system DORSODURO 1200 ABS - ATC
ELE SYS - 90