About «In the Event of….»
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 26
4. About «In the Event of….»
The subsequent chapters - In the event of…..- deal with different
events that may occur;
Chapter In the event of…..
Chapter 5 a fire alarm
Chapter 6 a fire alarm with alarm delay (in a Delayed Action detection
zone - immediate output actioning disabled)
Chapter 7 a pre-alarm
Chapter 8 faults
Chapter 9 supervisory condition
The list above covers the most common events. In addition to these, a
great number of combinations of events may, of course, occur.
For each event there is an overview of all indications on the panel,
plus the necessary actions to take. All alarm handling and display
pictures shown in the subsequent chapters are based on the
following:
The system is in Operation Mode.
To operate the panel, Access Level 2 is required. This means that
the person operating the panel, must use a key before the panel
can be operated. This is indicated with a key.
The examples show a system that is configured to immediately
trigger Fire Alarm Routing Equipment and send a message to a
Fire Receiving Station (Fire Brigade) in the event of a fire alarm.
The Remote Call indicator will thus come on.
As you proceed through the steps in the different events, the
comments field will, when necessary, provide additional information
and show the different options you have.
To Next Page
Loading...
Need help?
General
