Disabling
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 49
12.11 Disabling Loop IO Carriers
You can disable a single Loop IO Carrier, or all Loop IO Carriers.
A disable time span can be set. When the disable time span expires,
the Loop IO Carriers will automatically be enabled. The single Loop IO
Carrier or all Loop IO Carriers can also be enabled manually from the
Enable Menu.
12.12 Example – How to Disable a Detection Zone
The example below shows how to disable a Detection Zone. The
similar procedure applies to all other selections.
To enter the Menu Mode from operation mode or the panel’s idle
state, press and hold down the Enter button
for a few seconds.
Use the arrow down button to scroll down and select Disable.
Press the Enter button
.
Press the Enter button
.
To Next Page
Loading...
Need help?
General
