Show Unit Properties
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 59
14.7 Loop Outputs
Using the Enter button after selecting a loop output reveals the
following properties:
Name
Unit function
Using the Function button
after selecting a loop output gives the
following menu selections::
Not applicable to Fire Alarm Devices, Fire Alarm Routing Equipment
and Fault Warning Routing Equipment:
Show Activating Detection Zones
Show Activating Points
Show Activating Inputs
Show (activating) Activation Groups
Show Activaing Outputs
Not applicable to Fire Alarm Routing Equipment and Fault Warning
Routing Equipment:
Show Connected Units
To Next Page
Loading...
Need help?
General
