Enabling
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 53
13.8 Enabling Outputs (Loop Outputs/Local Outputs)
When you enable outputs which control Fire Protection Equipment
(FPE), signals will be sent to trigger the equipment upon the activation
of an output (caused by an alarm signal, input signal or output signal).
You can enable a single output.
13.9 Enabling Inputs (Loop Inputs/Local Inputs)
When you enable inputs, the signals from external equipment to the
inputs you enable will be received by the panel/system and actions
will be taken (for example, activation of general alarm or external
day/night activation). You can enable a single input or several inputs.
13.10 Enabling Routing Equipment
When you enable Fire Alarm Routing Equipment (FARE) and/or Fault
Warning Routing Equipment (FWRE), the output which controls such
equipment will be enabled.
Fire Alarm Routing Equipment (FARE): In the event of an alarm, fire
alarm signals may be sent to the fire brigade (configurable).
Fault Warning Routing Equipment (FWRE): In the event of a fault,
fault warning signals will be sent to, for example, the security firm.
13.11 Enabling Loop IO Carriers
You can enable a single Loop IO Carrier, or all Loop IO Carriers.
To Next Page
Loading...
Need help?
General
