Table of Contents
Operator's Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-OPERATE/FGB Rev. B, 2009-10-28,
Autronica Fire and Security AS
Page 2
5. In the Event of a Fire Alarm .............................................27
5.1 Indications in the Event of a Fire Alarm ............................................27
5.2 Actions to be Taken in the Event of a Fire Alarm..............................27
6. In the Event of a Pre Alarm..............................................32
6.1 Indications in the Event of a Pre Alarm.............................................32
6.2 Actions to be Taken in the Event of a Pre Alarm ..............................32
7. In the Event of a Fire Alarm - with Alarm Delay ...........34
7.1 Indications - Fire Alarm with Alarm Delay.........................................34
7.2 Actions to be Taken - Fire Alarm with Alarm Delay ..........................34
8. In the Event of Faults .......................................................37
8.1 Indications in the Event of Faults ......................................................37
8.2 Actions to be Taken in the Event of Faults .......................................37
9. Supervisory.......................................................................40
9.1 Indications during Supervisory..........................................................40
9.2 Actions to be Taken during Supervisory ...........................................40
10. Menu Mode........................................................................42
10.1 Menu Structure..................................................................................42
10.2 How to Enter Menu Mode .................................................................42
10.3 How to Enter Service Mode ..............................................................43
11. System Status...................................................................44
11.1 Introduction........................................................................................44
11.2 System Status Menu .........................................................................44
11.3 Example – System Status, Alarms....................................................44
12. Disabling............................................................................46
12.1 Introduction........................................................................................46
12.2 Disable Menu ....................................................................................46
12.3 Disabling Activated / Deactivated Components................................47
12.4 Disabling Detection Zones ................................................................47
12.5 Disabling Alarm Zones......................................................................47
12.6 Disabling Points.................................................................................47
12.7 Disabling Fire Alarm Devices............................................................48
12.8 Disabling Outputs (Loop Outputs/Local Outputs) .............................48
12.9 Disabling Inputs (Loop Inputs/Local Inputs)......................................48
12.10 Disabling Routing Equipment............................................................48
12.11 Example – How to Disable a Detection Zone ...................................49
13. Enabling ............................................................................51
13.1 Introduction........................................................................................51
13.2 Enable Menu .....................................................................................51
13.3 Enabling Deactivated Components...................................................52