Operation Mode
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 14
3. Operation Mode
3.1 Introduction
The operator panel can be in either Operation Mode or Menu Mode.
When no one is operating the panel and no button has been pressed,
the panel will always be in Operation Mode.
The display may look as follows in the panel’s idle state.
AUTROSAFE
SelfVerify
19:23
Total: 3
Figure 3-1: The idle display
Note that an alarm, a disablement, test or fault will always be indicated
on the display when such events occur.
It is possible to enter Operation Mode in two different ways.
• initial mode (start up) - idle state
• when pressing the menu button in Menu Mode, which will leave
menu mode from all menu levels
NOTE:
All events that may occur are presented in Operation Mode.
All handling of events, i.e. Silence Alarms, Accept and
System Reset takes place in Operation Mode.
To Next Page
Loading...
Need help?
General
