Operation Mode
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 24
3.16 Different Types of Detection Zones
3.16.1 Introduction
When handling events in Operation Mode, it is important to be aware
of differences regarding the detection zone configuration (configured
by using the AutroSafe Configuration Tool).
The type of the specific detection zone as well as the type of point
(detector or manual call point) will determine how the system responds
to the signal - with respect to action.
The system has the following types of detection zones:
• Immediate Action detection zone
• Coincidence Action detection zone
• Delayed Action detection zone
• Delayed Coincidence detection zone
• SOLAS (Safety of Life at Sea) detection zone
3.16.2 Immediate Action Detection Zones
A signal from an Immediate Action detection zone, will initiate all
actions immediately, without any delay.
Immediate Action applies to:
• Fire Alarm Devices (FAD)
• Fire Alarm Routing Equipment (FARE)
• Fire Protection Equipment (FPE)
To Next Page
Loading...
Need help?
General
