In the Event of a Fire Alarm -
with Alarm Delay
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. E, 021105,
Autronica Fire and Security AS
Page 36
Power
Fire Brig. Signalled
Function Delayed
Function Disabled
0
ALARM
ALARMALARM
ALARM
i
C
98
7
6
5
4
3
21
Mute Panel
Silence Alarms
Reset System
More Events
Testing
Fire Brig. Disabled
System Fa ult
Alarms Disabled
Fire Brig. Fault
Fault
!
!
Alarms Fault
6. In the Event of a Fire Alarm -
with Alarm Delay
6.1 Indications - Fire Alarm with Alarm Delay
The following shows the indications on the Operator Panel in the event
of «Fire Alarm with Alarm Delay» within the operation zone of the
panel.
The internal buzzer is
activated.
Default pattern on the
sound:
1 sec. ON, 1 sec. OFF
A point set to Delayed Action (configurable) is sending an alarm signal from a Delayed Action
detection zone in a situation where Immediate Output Actioning has been disabled, i.e. the alarm
delay has been activated.
NOTE:
An alarm from a manual call-point is normally configured to give immediate actioning on the
alarm outputs even though Immediate Output Actioning has been disabled.
The text display indicates the detection zones in alarm state and their
location. In addition, the following information is shown by operating the
menu:
- detailed zonal information
- information on the specific points in alarm
The red Alarm indicator is
blinking.
The Function Delayed
indicator has a steady
yellow light.
The Function Disabled
indicator has a steady
yellow light.
To Next Page
Loading...
Need help?
General
